September 2016 Service ManualTilt-back Frame, AWP-36S and 40S ModelsPart No. 38139 AWP Super Series • IWP Super Series 101Tilt-back Fr am e, AW P-36S and 40S Mod els6-1 Tilt- back Fr ame6-1Tilt-back FrameHow to Remove the Tilt-backframe1 Fully lower the platform.2 Turn the key switch off and remove the key.3 Maintain a firm grasp on the tilt-back frameand remove the retaining pin. Lower thetilt-back frame to the ground.4 Remove the fasteners that mount the tilt-backframe hinges to the base.Note: Note the amount of shims used between thehinges and the base.5 Remove the frame from the machine.How to Adjust the Loading Pivotor Stop BracketNote: Check for side-to-side movement of the pivotslider or stop bracket. They should have noside-to-side clearance and not be too tight to causedragging or binding. Adjust if necessary.1 Remove the tilt-back frame. Refer to RepairProcedure, How to Remove the Tilt-backFrame.2 Remove the mounting fasteners from thetilt-back frame hinges.3 Slide the pivot slider and the stop bracket outof the frame and add shims as necessary toobtain zero clearance and zero drag.1 shock absorber assembly2 tilt-back frame3 shock absorber mounting bolt4 loading pivot bar5 loading stop bracket
