Service Manual September 2016Platform106 AWP Super Series • IWP Super Series Part No. 3813912 Remove the lower sprocket housing mountingfasteners. Do not allow the chain to becometwisted.13 Remove the upper sprocket housing mountingfasteners. Do not allow the chain to becometwisted.14 Remove the fasteners from the outreachlocking bracket.15 Slide the platform mount off the inner frameextension arms and set it aside.16 Locate the two allen head screws in theplatform mount slide pad.17 Remove the roller from the same side of theslide pad.18 Remove the two allen head screws.19 Remove the master link from the chain.20 Pull the chain out of the slide pad and bothsprocket housings.21 Install the new chain through the slidepad.22 Push the chain through the slide pad untilapproximately 2 inches / 5 cm of the chain isextended past the slide pad.23 Install the two allen head screws. Install theroller wheel.24 Thread the chain through the upper sprockethousing over the sprocket, then back throughthe housing.25 Thread the chain through the lower sprockethousing over the sprocket, then back throughthe housing. Don't allow the chain to becometwisted.26 Do not re-use the old master link. Install a newmaster link.27 Slide the platform mount onto the extensionarms.28 Install the outreach locking bracket on theplatform mount.29 Install the upper sprocket housing to theplatform mount.Note: When fasteners are installed, be sure thecenter bolt is in between the two chains inside thehousing.30 Pull the slack out of the chain by pushingdown on the lower sprocket housing.31 Install the lower sprocket housing fasteners.32 Adjust the chain. Refer to Repair Procedure,How to Adjust the Platform Outreach Chain.33 Install the outreach assembly onto thecarriage.
