Test CartridgeUse the specially labeled test cartridge to perform diagnostics on the drive. Do notuse it to save or restore programs or data.Cleaning CartridgeUse the specially labeled cleaning cartridge to clean the tape drive (see “Cleaningthe Tape Drive” on page 8).To order additional cartridges, refer to “Ordering Tape Cartridges” on page 15.Guidelines for Using Tape CartridgesObserve the following guidelines for using media with the 7208 Model 345 TapeDrive:Attention: Do not use video-grade cartridges, as they are hazardous to the 7208Tape Drive and will void your warranty.Before using a cartridge, let it acclimate to the operating environment for as longas it has been away from the environment or for 24 hours, whichever is less.Use only IBM 8mm cartridges with the 7208 Model 345 Tape Drive. IBM onlysupports the use of IBM media. To order tape cartridges, see “Ordering TapeCartridges” on page 15.Attention: Clean the 7208 Tape Drive:v Whenever you replace a worn tapev Whenever you replace a defective tapev Whenever the CLEANING message displaysFor more information, see “Cleaning the Tape Drive” on page 8.Do not write to previously written software distribution tapes. Often these tapeswill not support being rewritten without modifications to the cartridge. If thecartridge is modified, it is possible to cause tape jams or tape misalignment.Back up and then discard any tape that repeatedly produces error messages. (Theerror information is in the System Error Log.)Do not open the door that covers the tape in the data cartridge. This door protectsthe magnetic tape from dirt, dust, and damage.Do not touch the tape material. Any substance transferred to the tape by touchingcould cause loss of data.Do not operate the 7208 Tape Drive in a dusty environment.Do not store tape cartridges or the 7208 Tape Drive in a dusty environment.Do not store tape cartridges flat. Store tape cartridges vertically on the long narrowspine in their protective case.12 7208 Model 345 Service Guide