IBM 7208 Model 345 Service Manual
                                                                    | |
Contents
|
To replace the power supply, reverse the removal procedure. Make sure to:v Align the power supply on the base of the chassis and inside the two tabs (8in Figure 13).v Insert the EMI gasket 7 between the power supply and the drive.v To reduce radiated noise, perform five full (360°) twists of the J1 power cable3.v With its locking features in a horizontal position, insert the power switch pushbutton 6 into the front panel and press until it locks in place.Note: If the power switch does not work properly, loosen the power supplymounting screw 2, slide the power supply to the rear of the chassis, andretighten the mounting screw.v Arrange the cables so that they do not interfere with the cooling fan blades orthe replacement of the cover. Ensure that they do not obstruct airflow throughthe fan.Note: The power supply connector J3 is not used in the 7208 Tape Drive.Figure 13. Removing and Replacing the Power SupplyChapter 4. Removal and Replacement Procedures 29 |
Related manuals for IBM 7208 345
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine