IBM 7208 Model 345 Service Manual

Contents

Table 7. Fault Symptom Codes (FSC) and Error Recovery Procedure (ERP) Numbers (continued)FSC Description ERP Number Cause05 The operation has aborted (as requested). 11D = 50%O = 50%06 An LEOT or LEOP was encountered on the last WRITEoperation. 10 I08 The compression data integrity check failed. 12 D = 100%09 An LEOT or LEOP was detected during a READoperation. 10 I0A A length mismatch was encountered on a READoperation. 15 I0B An uncorrectable block was encountered on a READoperation. 8,6D = 10%T = 90%0C An EOD mark was encountered on a READ operation. 13 I0D A filemark was encountered during a READ orVERIFY operation. 10 I0E An illegal condition exists that prohibits a READ orVERIFY operation. 2D = 50%S = 50%0F A READ operation was issued to blank tape. 4 I10 The READ operation has aborted (as requested). 11D = 50%O = 50%11 Too many permanent READ errors occurred. The drivecannot synchronize the data. 8,6D = 10%T = 90%14 PEOT or PEOP was encountered on a READ orVERIFY operation. 2,8,6D = 50%O = 50%15 An incorrect filemark was encountered during a READoperation. 8,6 T = 100%16 A media error was detected during a READ operation. 8,6D = 10%T = 90%17 A hardware error occurred during a READ operation. 12 D = 100%18 READ decompression failed — HW error. 12 D = 100%19 Cyclic Redundancy Check (CRC) failed during the readoperation after decompression 12 D = 100%1C The tape is in an unknown or incompatible format. 14 T = 100%1DA setmark was encountered during a READ or VERIFYoperation. A setmark is a location finding mark that isset on the tape.10 I26 A WRITE FILEMARKS (WFM) command was receivedwhen the tape was not at a legal position to write. 2O = 50%S = 50%27 The tape is write-protected for WRITE FILEMARKS(WFM). 5 I28 An LEOT or LEOP was encountered during a WRITEFILEMARKS (WFM). 10 I42 7208 Model 345 Service Guide