Removing and Replacing the CoverTo remove the cover from the 7208 Tape Drive:1. If a tape cartridge is loaded in the drive, eject it.2. Do a controlled system shutdown (refer to the instructions in Chapter 2,“Setting up the 7208 Tape Drive,” in the 7208 Model 345 8mm Tape Drive Setupand Operator Guide).3. If it is on, turn off the power to the 7208 Tape Drive.4. Unplug the 7208 Tape Drive power cable from the electrical outlet.5. Disconnect the power cable from the 7208 Tape Drive.6. Disconnect the SCSI bus (signal) cable from the 7208 Tape Drive.7. Tilt the 7208 Tape Drive on its side and remove the four cover mounting screwsfrom the bottom (see Figure 11).8. Remove the cover by sliding it to the rear (see the directional arrow inFigure 11).To replace the cover, reverse the removal procedure.Figure 11. Removing and Replacing the Cover26 7208 Model 345 Service Guide
