6. Position the drive so that it faces you.7. Take up slack in the tape by using the following instructions to move thedrive’s trolleys and the supply reel motor.Attention: To avoid damaging the tape, do not touch it.v To move the drive’s trolleys:a. On the left side panel of the drive (toward the rear) locate the holemarked UNLOAD (1 in Figure 16).b. Insert a 2.5-mm L-Hex (allen) wrench approximately 43 mm (2 in.) intothe UNLOAD hole. Position it so that it seats securely into the inner socket.c. Turn the wrench in the direction marked on the drive (clockwise).d. Rotate the wrench until the trolleys 2 stop moving. This may takemore than 120 turns of the wrench.Figure 16. Moving the Trolleys32 7208 Model 345 Service Guide
