IBM 7208 Model 345 Service Manual

Contents

Table 7. Fault Symptom Codes (FSC) and Error Recovery Procedure (ERP) Numbers (continued)FSC Description ERP Number Cause31 A setmark was encountered during a SPACE orLOCATE operation. 10 I32 A filemark was detected during SPACE or LOCATEoperation. 10 I33 An EOD was encountered on a SPACE or LOCATEoperation. 10 I34 A PEOT or PEOP was encountered on a SPACE orLOCATE operation. 8,6 T = 100%35 A PBOT or PBOP was encountered on a SPACE orLOCATE operation. 2 I36 A format error occurred during a SPACE or LOCATEoperation. 8,6D = 20%T = 80%37 An uncorrectable block was encountered during aSPACE or LOCATE operation. 8,6D = 10%T = 90%38 A media error occurred during a SPACE or LOCATEoperation. 8,6D = 20%T = 80%3A An incorrect filemark was encountered during aSPACE operation. 3 T = 100%3B The SPACE/LOCATE operation has aborted (asrequested). 11D = 50%O = 50%3D There is no information at this position on tape. Thetape drive cannot perform a space operation. 8,6D = 20%T = 80%47 An incompatible media cartridge was rejected afterloading. 14O = 90%T = 10%4B The tape is at an illegal position for an ERASEoperation. 2O = 50%S = 50%4C The tape is write-protected for an ERASE operation. 5D = 5%O = 90%T = 5%4E The ERASE operation has aborted (as requested). 11D = 5%O = 90%S = 5%58 A hardware error occurred during the SENDDIAGNOSTIC operation. 12 D = 100%61 The microcode header was not valid when loadingfirmware. 8,6 T = 100%63 The CONTROL LOAD image is not valid. 8,6 T = 100%65 The EEPROM load image is not valid. 8,6 T = 100%66 The Boot microcode is downlevel. 8,6 T = 100%Appendix B. Fault Symptom Codes 43