IBM NetVista X40 User Manual

Contents

Table 7. NDIS (Windows NT) driver messages for the Ethernet controller (continued)Error code (hex) Description0x0E Explanation: Could not allocate enough memory for receive queue. Action:1. From the Windows NT desktop, select Start --> Control Panel --> Networks --> Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties --> Advanced.4. Lower the resource values that apply to the receive queue.0x0F Explanation: Could not allocate enough memory for other structures. Action:1. From the Windows NT desktop, select Start --> Control Panel --> Networks --> Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties --> Advanced.4. Lower the value for the resource named in the message.0x10 Explanation: Did not find any Ethernet controllers. Action:Using the Configuration/SetupUtility program, make sure that Ethernet is enabled.0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID.Action:Using the Configuration/Setup Utility program, make sure that Ethernet is enabled.0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev.Action:Using the Configuration/Setup Utility program, make sure that Ethernet is enabled.0x16 Explanation: Single adapter found, but multiple instances tried to load. Action:Using theConfiguration/Setup Utility program, make sure that Ethernet is enabled, and that the slotcontaining the IBM IntelliStation 10/100 Ethernet Adapter or the IBM 10/100 Etherjet PCIadapter is enabled.0x17 Explanation: Slot parameter not specified in the registry. Action:Remove the adapter driver andreinstall it. If the problem persists, call for service.All other4-characterhexadecimalcodesAction:Call for service.Ethernet teaming messagesThis section displays the messages associated with Ethernet teaming.Table 8. NDIS (Windows NT ) driver teaming messages for the Ethernet controllerEvent ID Type Description01 Error Explanation:Team Name and physical adapter name are the same. This isan invalid configuration. Action:Reconfigure the adapter team bydouble-clicking the PROSeticon in the control panel.02 Error Explanation:Unable to allocate required resources. Action:Free somememory resources and restart.03 Error Explanation:Unable to read required registry parameters.Action:Reconfigure the adapter team by double-clicking the PROSeticonin the control panel.04 Error Explanation:Unable to bind to physical adapter. Action:Reconfigure theadapter team by double-clicking the PROSet icon in the control panel.05 Error Explanation:Unable to initialize an adapter team. Action:Reconfigure theadapter team by double-clicking the PROSet icon in the control panel.06 Informational Explanation:Team nn. Primary adapter is initialized. Action:None.07 Informational Explanation:Team nn. Secondary adapter is initialized. Action:None.08 Informational Explanation:Team nn. Virtual adapter or Team is initialized. Action:None.Chapter 6. Solving problems 97