| 
If you forget the power-on password, you can regain access to the computerthrough either of the following methods:v Start the Configuration/Setup Utility program and change the power-onpassword.v Change the jumper position on the complimentary metal oxide semiconductor(CMOS) jumper as described in “Clearing CMOS” on page 103.Using the SCSISelect Utility program (some models)SCSISelect is a built-in, menu-driven configuration utility program that you canuse to:v View the default SCSI IDsv Locate and correct configuration conflictsThe following sections provide the instructions for starting the SCSISelect Utilityprogram and descriptions of the menu choices that are available.Starting the SCSISelect Utility programComplete the following steps to start the SCSISelect Utility program:1. Turn on the computer.2. When the <<< Press for SCSISelect ™ Utility! >>> promptappears, press Ctrl+A.3. When the Would you like to configure the host adapter or run the SCSIdisk utility? question appears, make your selection and press Enter.4. Use the arrow keys to select a choice from the menu.v Press Esc to exit the SCSISelect Utility program.v Press the F5 key to switch between color and monochrome modes (if yourmonitor permits).5. Follow the instructions on the screen to change the settings of the selecteditems; then, press Enter.Choices available from the SCSISelect menuThe following choices appear on the SCSISelect Utility menu:v Configure/View Host Adapter SettingsSelect this choice to view or change the SCSI controller settings. To reset theSCSI controller to its default values, press F6; then, follow the on-screeninstructions.You can view or change the following controller settings:– Host Adapter SCSI IDSelect this choice to view the SCSI controller identification (ID), which isusually 7.– SCSI Parity CheckingSelect this choice to view the assigned value of Enabled.– Host Adapter SCSI TerminationSelect this choice to view the assigned value of Automatic.– Boot Device OptionsSelect this choice to configure startable-device parameters. Before you canmake updates, you must know the ID of the device whose parameters youwant to configure.– SCSI Device Configuration30 IBM®IntelliStation®E Pro: User’s Guide IntelliStation E Pro Types 6836, 6846 |
