v Connect the Ethernet cable to the RJ-45 Ethernet connector.Important:To operate the computer within FCC Class A limits, use a category 5Ethernet cable.3. Connect the power cord to the power connector located on the rear of thecomputer. If there is a label covering the power connector, remove it.Attention: If you have a desktop model, check the position of thevoltage-selection switch. Use a ball point pen to slide the switch, if necessary.v If the voltage supply range in your location is 90-137 V ac, set the voltageswitch to 115 V.v If the voltage supply range in your location is 180-265 V ac, set the voltageswitch to 230-265 V.4. Connect the power cords into properly grounded electrical outlets.Note: When the power cord is first plugged in, the computer might turn on fora few seconds, then turn off. This is normal.Starting your computer for the first timeThis section contains the information that you will need to start operating yourcomputer.1. Review the safety precautions listed in Statement 1 and Statement 5 in “Safety”on page v.2. If your computer is a desktop model, set the voltage-selection switch locatednext to the power cord connector on the rear of the computer.EthernetPowerVoltage switch11512 IBM®IntelliStation®E Pro: User’s Guide IntelliStation E Pro Types 6836, 6846
