| 
v Set or read current system management adapterv Set lockout thresholdUsing the SCSISelect utility programSCSISelect is a built-in, menu-driven configuration utility program that you canuse to:v View the default SCSI IDsv Locate and correct configuration conflictsv Perform a low-level format on a SCSI hard diskThe following sections provide the instructions needed to start the SCSISelectUtility and descriptions of the menu choices available.Note: If your server has a RAID adapter installed, use the configuration methodsupplied with the RAID adapter to view or change SCSI settings for devicesattached to the adapter.Starting the SCSISelect utility programTo start the SCSISelect utility program:1. Turn on the server.2. When the <<< Press for SCSISelect ™ Utility! >>> promptappears, press Ctrl+A.3. When prompted, select either channel A or channel B.4. Use the arrow keys to select a choice from the menu.v Press Esc to return to the previous menu.v Press the F5 key to switch between color and monochrome modes (if yourmonitor permits).5. Follow the instructions on the screen to change the settings of the selecteditems; then, press Enter.Choices available from the SCSISelect menuThe following choices appear on the SCSISelect Utility menu:v Configure/View Host Adapter SettingsSelect this choice to view or change the SCSI controller settings. To reset theSCSI controller to its default values, press F6; then, follow the instructions thatappear on the screen.You can view or change the following controller settings:– Host Adapter SCSI IDSelect this choice to view the SCSI controller ID, normally 7.– SCSI Parity CheckingSelect this choice to view the assigned value of Enabled.– Host Adapter SCSI TerminationSelect this choice to view the assigned value of Enabled.– Boot Device OptionsSelect this choice to configure startable device parameters. Before you canmake updates, you must know the ID of the device whose parameters youwant to configure.– SCSI Device ConfigurationUsing the Configuration/Setup Utility programConfiguring the server 29 |
