The following illustration shows the rerouting of the SCSI cable if you install aServerRAID adapter.SCSIconnector A (J24)To install an adapter:1. Review the information in “Before you begin” on page 42.2. Turn off the server and peripheral devices and disconnect all external cablesand power cords; then, remove the cover (see “Removing the cover and bezel”on page 44).3. Determine which expansion slot you will use for the adapter.Attention: Check the instructions that come with the adapter for anyrequirements or restrictions.4. Remove the expansion-slot cover:a. Loosen and remove the screw on the top of the expansion-slot cover.b. Slide the expansion-slot cover out of the server. Store it in a safe place forfuture use.Attention: Expansion-slot covers must be installed on the openings for allvacant slots. This maintains the electromagnetic emissions characteristics ofthe system and ensures proper cooling of system components.5. Refer to the documentation that comes with your adapter for any cablinginstructions. It might be easier for you to route any cables before you installthe adapter.6. Remove the adapter from the static-protective package.Attention: Avoid touching the components and gold-edge connectors on theadapter.7. Place the adapter, component-side up, on a flat, static-protective surface.8. Set any jumpers or switches as described by the adapter manufacturer.9. Install the adapter:a. Carefully grasp the adapter by its top edge or upper corners, and align itwith the expansion slot on the system board.b. Press the adapter firmly into the expansion slot.48 Hardware Maintenance Manual: xSeries 342 Model 1RX, 2RX, 1TG, 2TG
