v Review the documentation that comes with the adapter and follow thoseinstructions in addition to the instructions given in this section. If you need tochange the switch or jumper settings on your adapter, follow the instructionsthat come with the adapter.v You can install full-length adapters in all expansion slots.v You can install a 32-bit adapter in any of the PCI slots.v Your server supports 5.0 V signalling and universal PCI adapters in slots 1, 2,and 3; it supports 3.3 V signalling or PCI adapters in slots 4 and 5.v Your server uses a rotational interrupt technique to configure PCI adapters.Because of this technique, you can install a variety of PCI adapters that currentlydo not support sharing of PCI interrupts.v PCI slot 1 is on PCI bus A, PCI slots 2 and 3 are on PCI bus B, and PCI slots 4and 5 are on PCI bus C. The system scans PCI slot 1, the system board Ethernet,PCI slots 2-5, the system board SCSI, channel A, and the system board SCSIchannelB, if you have not changed the boot precedence from the default.You can use the Configuration/Setup Utility program to change the bootprecedence for your server. Select Start Options from the Configuration/SetupUtility program.Note: The Remote Supervisor Adapter must be installed in PCI slot 1.Adapter installation instructionsAdapterExpansion-slot coverInstalling options 47
