Note: When the server is in the locked position, you can reach the cables onthe back of the server.4. Lift the cover-release latch. Lift the cover off the server and set the cover aside.Attention: For proper cooling and airflow, replace the cover before turning onthe server. Operating the server for extended periods of time (over30 minutes) with the cover removed might damage servercomponents.To remove the bezel:1. Press in on the top sides of the bezel and pull the bezel away from the serverfront.2. Store the bezel in a safe place.Working with adaptersYou can install up to five peripheral component interconnect (PCI) adapters in theexpansion connectors on the system board.Your server comes with a video controller. This video controller is an integratedcomponent on the system board. It is not removable. If you want to disable thiscontroller and use a video adapter instead, you can install a video adapter in anexpansion slot. When you install a video adapter, the server BIOS automaticallydisables the integrated video controller.The following illustration shows the location of the PCI expansion slots on thesystem board.PCI Slot 132-bit33 MHz (J44)PCI Slot 264-bit33 MHz (J41)PCI Slot 364-bit33 MHZ (J42)PCI Slot 464-bit66 MHz (J29)PCI Slot 564-bit66 MHz (J30)Adapter considerationsBefore you continue with the adapter-installation procedure:46 Hardware Maintenance Manual: xSeries 342 Model 1RX, 2RX, 1TG, 2TG
