The processing sequence for SCSI devices is set through the SCSISelect Utilityprogram. The default sequence proceeds from the lowest SCSI ID to the highest (0to 15). The SCSI controller uses ID 7.Ensure that the device you are installing is not terminated. It is not necessary to settermination jumpers on internal SCSI devices. The server hardware providestermination for all internal SCSI devices.Installing a hot-swap driveThe hot-swap drive bays support hot-swap drives only.This section gives the procedure for installing a hot-swap hard disk drive. If youwant to remove a drive, reverse the following steps.Notes:1. To minimize the possibility of damage to the hard disk drives, install the serverin the rack before installing the hard disk drives.2. You do not have to turn off the server to install hot-swap drives. However, youmust turn off the server when performing any steps that involve installing orremoving cables.Drive-tray assemblyDrive handleFiller panelTo install a drive in a hot-swap drive bay:1. Review the information in “Before you begin” on page 42.Attention: To maintain proper system cooling, do not operate the server formore than two minutes without either a drive or a filler panelinstalled for each bay.2. Remove the filler panel from one of the empty hot-swap bays by inserting yourfinger into the depression on the filler panel and pulling it away from theserver.3. Install the hard disk drive in the hot-swap bay:a. Ensure the tray handle is open (that is, perpendicular to the drive).b. Align the drive/tray assembly with the guide rails in the bay.Installing options 51
