AFL2-12A-D525 Series Panel PCPage 146Step 12: The recovery tool main menu window is shown as below. Press any key toreboot the system. Step0:Figure C-21: Press Any Key to ContinueC.3 Setup Procedure for LinuxThe initial setup procedures for a Linux system are mostly the same with the procedure forMicrosoft Windows. Please follow the steps below to setup the recovery tool for Linux OS.Step 1: Hardware and BIOS setup. Refer to Section 7 7 C.2.1.Step 2: Install Linux operating system. Make sure to install GRUB (v0.97 or earlier)MBR type and Ext3 partition type. Leave enough space on the hard drive tocreate the recover partition later.NOTE:If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,the Symantec Ghost may not function properly.While installing Linux OS, please create two partitions: Partition 1: / Partition 2: SWAP