AFL2-12A-D525 Series Panel PCPage 353.1 UnpackingTo unpack the flat bezel panel PC, follow the steps below:WARNING!The front side LCD screen has a protective plastic cover stuck to thescreen. Only remove the plastic cover after the flat bezel panel PC hasbeen properly installed. This ensures the screen is protected during theinstallation process.Step 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of theexternal (second) box.Step 2: Open the external (second) box.Step 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of theinternal (first) box.Step 4: Lift the monitor out of the boxes.Step 5: Remove both polystyrene ends, one from each side.Step 6: Pull the plastic cover off the flat bezel panel PC.Step 7: Make sure all the components listed in the packing list are present. Step 0:3.1.1 Packing ListThe AFL2-12A-D525 flat bezel panel PC is shipped with the following components:Quantity Item ImageStandard1 AFL2-12A-D525 panel PC