AFL2-12A-D525 Series Panel PCPage 524.9.2 Panel MountingTo mount the AFL2-12A-D525 flat bezel panel PC into a panel, please follow the stepsbelow.Step 1: Select the position on the panel to mount the flat bezel panel PC.Step 2: Cut out a section from the panel that corresponds to the rear panel dimensionsof the flat bezel panel PC. Take care that the panel section that is cut out issmaller than the overall size of the frame that surrounds the flat bezel panel PCbut just large enough for the rear panel of the flat bezel panel PC to fit throughStep 3: Slide the flat bezel panel PC through the hole until the frame is flush against thepanel.Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges ofthe chassis, behind the frame.Step 5: Tighten the screws that pass through the panel mounting clamps until the plasticcaps at the front of all the screws are firmly secured to the panel (Figure 4-13).Step 0: