275 MEMORY OPERATIOND Programming a memory channel via the microphoneThe microphone can also be used to program mem-ory channels.z Set the desired frequency in VFO mode.➥ Push [VFO/LOCK] to select VFO mode.➥ Set the frequency using the keypad.➥ Set other data (e.g. offset frequency, duplex direction, sub-audible tone encoder ON/OFF and its frequency) , if neces-sary.x Push [FUNC] then [CLR A(MW)] momentarily.c Push [Y] or [Z] to select the memory channel.• Direct numeral input cannot be used.v Push [FUNC] then [CLR A(MW)] for 1 sec. to program.➥ 3 beeps may sound and the VFO contents (includingthe subaudible tone frequency, etc.) are programmed.➥ Memory channel number increases when continuing topush [CLR A(MW)] after programming.MW[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the microphone.Push 10 timesBeep“Beep“BeepBeepBeep“““““Push Push thenPush then for 1 sec. and continue to push ➠
