IIQUICK REFERENCE GUIDED LocationSelect a location which can support the weight of the trans-ceiver and does not interfere with driving. We recommend thelocations shown in the diagram below.NEVER place the transceiver or remote controller where nor-mal operation of the vehicle may be hindered or where itcould cause bodily injury.NEVER place the transceiver or remote controller where airbag deployment may be obstructed.DO NOT place the transceiver or remote controller where hotor cold air blows directly onto it.AVOID placing the transceiver or remote controller in directsunlight.D Using the mounting bracketqDrill 4 holes where the mounting bracket is to be installed.• Approx. 5.5–6 mm when using nuts; approx. 2–3 mm when usingself-tapping screws.wInsert the supplied screws, nuts and washers through themounting bracket and tighten.eAdjust the angle for your suitable position.IMPORTANT!Detailed installation notes for Icom mobile transceivers tobe fitted into vehicles are available. Contact your Icomdealer or distributor.25˚NutSpring washerWhen usingself-tappingscrewsFlat washerMounting nutMountingbracket @@ÀÀ QQ¢¢ @À Q¢ @À Q¢ @À Q¢ControllerMain unitMain unitMain unitQuick reference guide
