Icom IC-R30 Advanced Manual

Also see for IC-R30: Setup instructions Service manual Basic Manual Advanced manual

6 MENU SCREEN6-21■ Function (Continued)USB Connect (Default: Serialport)[MENU] > Function > USB ConnectSelect the mode when connecting the receiver to a PC with a USB cable.• Charge Only: You can only charge the receiver using a USB cable.• Serialport: You can program the receiver, output D-STAR data, GPS information,and remotely control the receiver using the CI-V commands.• SD Card Mode*: You can transfer the files between the inserted microSD card and aPC, using an USB cable.*A confirmation dialog is displayed.TIP: Application setting to output D-STAR data:Configure the communication software as follows.• Port: COM port number that is used by the receiver.*• Baud rate: 4800/9600 bps• Data bit: 8 bit• Parity: none• Stop bit: 1 bit• Flow control: Xon/Xoff* Depending on the PC environment, the COM port number used by the receiver maybe higher than 5. In that case, use an application that can set it to higher than 5.NOTE:• Confirm that the “Internal GPS” is selected, when you output the received positiondata.([MENU] > GPS > GPS Set > GPS Select)• While in the SD Card Mode, the receiver works not as a receiver but as a data storagedevice. It temporarily stops recording and logging.TIP: Removing the receiver in the SD card mode1. Click “ ,” and then click “Eject IC-R30.”2. Confirm “Safe To Remove Hardware” is displayed, and then remove the USB cablefrom the PC.