123SETTING A FREQUENCY123456789101112131415161718192021 PreparationD Turning power ON/OFF➥ Push [PWR] for 1 sec. toturn power ON or OFF.D VFO mode selectionThe transceiver has 2 basic operating modes: VFO mode andmemory mode.➥ Push [V/MHz(SCAN)] toselect VFO mode.➥ Push [VFO/LOCK] to select VFO mode. Using the tuning dialqRotate the tuning dial to set the frequency.• If VFO mode is not selected,push [V/MHz(SCAN)] to selectVFO mode.• The frequency changes ac-cording to the selected tuningsteps. (p. 00)wTo change the frequency in 1 MHz (10 MHz for some ver-sions) steps, push [V/MHz(SCAN)], then rotate the tuningdial.• Pushing [V/MHz(SCAM)] for1 sec. starts scan function. Ifscan starts, push[V/MHz(SCAN)] again to can-cel it.The display shows that the1 MHz tuning step is selected.Tunig dial[V/MHz(SCAN)]VFO/LOCKPush [V/MHz(SCAN)]Push [PWR] for 1sec.Note that in this manual, sections beginning with a micro-phone icon (as above), designate operation via the HM-133V microphone.