4610DTMF MEMORY ENCODER123456789101112131415161718192021 Transmitting a DTMF codeD Automatic transmission (DTMF memory)z Push [FUNC] then [ LOW 6(DTMF)] to turn theDTMF encoder ON.• “d” appears in place of the 100 MHz digit.x Push [ SET B(D-OFF)] to enter the DTMF mem-ory programming condition.c Push [Y] or [Z] to select the desired channel.v Push [PTT] to transmit the selected memory.• Exit the programming condition automatically.• Each push of [PTT] transmits the DTMF code.b Push [FUNC] then [SET B(D-OFF)] to cancel theDTMF encoder.• When the DTMF encoder is turned ON continuously,each push of the PTT transmits the previously se-lected DTMF code.D Transmitting a DTMF memory directlyz Push [DTMF-S] to turn the DTMF memory di-rect selection ON.• The function indicator (microhpne) lights green.x Push the desired DTMF channel number.• “0” to “9” are available for channel numbers.• Automatically transmits the selected DTMF code.NOTE: When no DTMF code programmed channelnumber is pushed, transmits for 1 sec. with-out DTMF code.c Push [DTMF-S] again to deactivate the DTMFmeory direct selection.D Manual transmissionz Push [DTMF-S] to turn the DTMF memory di-rect selection ON.• The function indicator (microhpne) lights green.x Push one of “A” to “F” key momentarily, thenpush the desired DTMF keys.• A: [CLR A(MW)] B: [ SET B(D-OFF)],C: [ENT C(T-OFF)] D: [ SQLY D(MUTE)],E: [✱(TONE-1)] F: [SQLZ #(16KEY-L)]• Automatically transmits without pushing PTT.• The first code, one of “A” to “F”, does not transmit-ted. DTMF code transmission started from the 2ndcode.c Push [DTMF-S] again to deactivate the DTMFmeory direct selection.DTMF-SDTMF-SDTMF