336 MEMORY OPERATION Memory bank settingq Push [MR/CALL] to select memory mode, then select thedesired memory channel via the tuning dial.w Push [BANK(OPT)].• “M” and “– –” indication blink as follow.e Push [BANK(OPT)] again to set the channel to bank set-ting stand-by condition.• “M” and “– –” indication blinking stop.r Push [MW(S.MW)] then rotate the tuning dial to select thedesired bank to be set.• Bank initial blinks as follow.t Push [MW(S.MW)] again to set the channel into the bank.• Bank initial blinking stops.y Push [BANK(OPT)] twice to return to regular memory con-dition.u Repeat steps q to y to set an another memory channelinto the same or another bank.z Push [MR/CALL] then select the desiredmemory channel via [Y]/[Z] or keypad.x Push [BANK/OPTION].• “– –” indication blinks.c Push [BANK/OPTION] again to set thechannel to bank setting stand-by condition.• “– –” indication blinking stops.v Push [FUNC] then [CLR A(MW)] then push[Y]/[Z] to select the desired bank to beset.• Bank initial blinks.b Push [ CLR A(MW)] to set the channel intothe bank.• Bank initial blinking stops.n Push [BANK/OPTION] twice to return toregular memory channel condition.m Repeat steps z to n to set an anothermemory channel into the same or anotherbank.BANK/OPTIONMW[Y]/[Z]BlinksS.MWMWBlinksOPTBANK