4811POCKET BEEP AND TONE SQUELCH123456789101112131415161718192021 Pocket beep operationThis function uses subaudible tones for calling and can beused as a “common pager” to inform you that someone hascalled while you were away from the transceiver.D Waiting for a call from a specific stationq Set the operating frequency.w Push [SET(LOCK)] to enter set mode.e Push [SET(LOCK)] or [MW(S.MW)] several times until “Ct”for tone squelch or “dt” for DTCS squelch appears.r Rotate the tuning dial to select the desired tone squelchfrequency or DTCS code and porality.t Push [V/MHz(SCAN] to exit set mode.y Push [TONE(T-SCAN)] several times to indicate “ ” fortone squelch or “ D ” for DTCS squelch in the functiondisplay.u When a signal with the matched tone is received, thetransceiver emits beep tones and flashes “ ”.• Beep tones sound for 30 sec and “ ” flashes. To stop the beepsand flashing manually, push any key. When the beep tones arenot stopped manually, “ ” continues flashing until step i.i Push [PTT] to answer.o Push [TONE(T-SCAN)] several times to cancel the func-tion.z Set the operating frequency.x Program the CTCSS tone frequency or DTCS code in setmode.• See p. 18 for programming details.c Push [FUNC] then [iT SQLS] to turn the pocket beepON.v When a signal with the matched tone is received, thetransceiver emits beep tones for 30 sec. and flashes“S”.b Push [PTT] to answer or push [clr A(MW)] to stop thebeeps and flashing.• Tone squelch is automatically selected.• Pushing [FUNC] then [oTSQL] also selects thetone squelch.n To cancel the function, push [FUNC] then [GT-OFF].D Calling a waiting station using pocket beepA subaudible tone matched with the station’s CTCSS tone fre-quency or 3-digit DTCS code with polarity is necessary. Usethe tone squelch on the next page or a subaudible tone en-coder (pgs. 00, 00) Tone squelch operationThe tone squelch opens only when receiving a signal with thesame pre-programmed subaudible tone.Tone squelch frqueency setting DTCS code setting