398 SCAN OPERATION Scan edges programmingScan edges can be programmed in the same manner asmemory channels. Scan edges are programmed into scanedges, 1A/1b to 3A/3b, in memory channels.q Set the edge frequency of the desired frequency range inVFO mode:➥ Set the frequency using the tuning dial.➥ Set other data (e.g. repeater settings, etc.) if desired.w Push [MW(S.MW)] momentarily.• “M” indicator and channel number blink.e Rotate the tuning dial to select one of scan edge channel,1A, 2A or 3A.r Push [MW(S.MW)] for 1 sec. to program.• 3 beeps sound and the frequency is programmed.• Scan edge 1b, 2b or 3b is automatically selected when continu-ing to push [MW(S.MW)] after programming.t To program a frequency for the other pair of scan edges,1b, 2b or 3b, repeat steps e and r.• If the same frequency is programmed into a pair of scan edges,programmed scan will not function.[EXAMPLE]: Programming 145.300 MHz and 145.800 MHz into scan edges 1A and 1b, respectively.Push momentarily.Rotate for setting frequency, etc. RotateS.MWMWPush for 1 sec. and continue to pushing ➠S.MWMWBeepBeepBeep“Beep“““““