367CALL CHANNEL OPERATION123456789101112131415161718192021 Programming a call channelIn addition to an operating frequency, duplex information, sub-audible to information (ton encoder or tone squelch ON/OFFand its frequency) and an alphanumeric channel names canbe programmed into the call channel.q Set the desired frequency in VFO mode.➥ Push [V/MHz(SCAN)] to select VFO mode.➥ Set the frequency using the tuning dial.➥ Set other data as desired.w Push [MW(S.MW)] momentarily.e Rotate the tuning dial to select the call channel• “M” indicator and large “C” blink.r Push [MW(S.MW)] for 1 sec. to program.• 3 beeps sound and return to VFO mode automatically.z Set the desired frequency in VFO mode.➥ Push [VFO/LOCK] to select VFO mode.➥ Set the frequency.➥ Set other data as desired.x Push [FUNC], then [CLR A(MW)] momentarily.c Select the call channel via [Y] or [Z] .v Push [FUNC] then [ CLR A(MW)] for 1 sec. toprogram.• 3 beeps sound and the return to VFO mode auto-matically.MR/CALLMW[Y]/[Z][EXAMPLE]: Programming 145.120 MHz into the call channel via the microphone.Set the frequency.Push to select VFO mode. Push , then .Push , then push for 1 sec. ➠Push until large “C” appears.BeepBeepBeep“““““