43D-STAR GUIDED-STAR OPERATION■ Accessing repeatersThis section describes how to check whether or not you canaccess your local area repeater (access repeater), and yoursignal is successfully sent to a destination repeater.TIP: If your call sign (MY) has not been set, or your callsign and D-STAR equipment have not been registered ata D-STAR repeater, see pages 39 ~ 42.Step 1: Set “FROM” (Access repeater).1. Push [DR] to select “FROM” then push [ENT].2. Select “Repeater List.”3. Select the repeater group where your access repeateris listed.4. Select your access repeater.• Returns to the DR screen, and the selected repeater name isdisplayed in “FROM.”L By just selecting the repeater name, the repeater call sign,its frequency, duplex setting, and frequency offset areautomatically set.L A repeater list here is just an example.TIP: There are several ways to set your access repeater.(p. 60)• Setting by [DIAL]• Searching for a repeater using the DR scan• Searching for the nearest repeater• Setting from the TX History[ENT][Down][Up](Example: “Kirkland (IA)”)(Example: “USA West”)
