63D-STAR GUIDED-STAR OPERATIONPROBLEM POSSIBLE CAUSE SOLUTION REF.After your call, the repeaterreplies ‘RPT?’ and the destinationrepeater’s call sign.• The repeater cannot connect to thedestination repeater.• The repeater is busy.• Check the repeater settings.• Wait for a while, and try it again.—Even holding down [DR], the DRscreen is not displayed.• There is no repeater list in your transceiver.• The Lock function is activated.• Import the repeater using a microSD card.• Directly enter the Repeater list data into thetransceiver.• Hold down [ ] for 1 second to turn OFF theLock function.p. 57AM*Sec. 4—Even holding down [RX→CS], thereceived call sign will not set to thedestination call sign.• The call sign has not been correctlyreceived.• When a received signal is weak, or a signalis received during scanning, the call signmay not be received correctly. In that case,“--------” is displayed and error beeps sound,and a reply call cannot be made.Try it again, after the transceiver has correctlyreceived the call sign.—A Local area call can be made,but the Gateway call or destinationstation call cannot be made.• MY call sign has not been registered on aD-STAR repeater.• The repeater set in “FROM” (AccessRepeater) has no Gateway.• Register your own call sign (MY) on a gatewayrepeater, or confirm the registration of the callsign.• Check the repeater settings.p. 41“L” is displayed on the LCD. While receiving through the internet, somepackets may be lost due to network error(poor data throughput performance).Wait a while, and try it again.L When the transceiver receives corrupteddata, and misidentifies it is as Packet Loss,“L” is displayed, even if it is a Local area call.—“DV” and “FM” icons alternatelyblink.While in the DV mode, an FM signal isreceived.Use a different operating frequency until thereare no FM signals on the original frequency.AM*Sec. 4* “AM” indicates the PDF type ADVANCED MANUAL.