Icom ID-31E PLUS Basic Manual

Also see for ID-31A PLUS: Manual Manual Advanced manual

Contents

Icom ID-31E PLUS Basic Manual Manual pdf 75 page image

62D-STAR GUIDED-STAR OPERATIONPROBLEM POSSIBLE CAUSE SOLUTION REF.After your call, the repeater doesnot return a status reply.• The repeater setting is wrong.• Your transmission did not reach the repeater.• Select the correct repeater.• Correct the repeater frequency, frequencyoffset, or duplex settings.• Wait until you are closer to the repeater andtry again.• Try to access another repeater.p. 60———After your call, the repeater replies‘UR?’ and its call sign.The call was successfully sent, but no stationimmediately replied.Wait for a while, and try again.—After your call, the repeater replies‘RX’ or ‘RPT?’ and the accessrepeater’s call sign.• Your own call sign (MY) has not been set.• Your own call sign (MY) has not beenregistered on a gateway repeater, or theregistered contents do not match yourtransceiver’s settings.• Set your own call sign (MY).• Register your own call sign (MY) on a gatewayrepeater, or confirm the registration of the callsign.p. 39p. 41After your call, the repeater replies‘RPT?’ and the access repeater’scall sign.The call sign of the destination repeater iswrong.Correctly set the destination repeater call sign.—To communicate through the repeater, your signal must access to the repeater. The following chart is designed to help youcorrect problems which are not equipment malfunctions.■ When receiving no reply