Contents - Table Of Contents
- Table Of Contents
- Table Of Contents
- General
- Safety
- Limits of operation and use
- Risk from electrocution
- Personnel requirements - Qualifications
- Transport, storage and packaging
- Storage
- Technical data
- Construction and function
- Wear parts list
- Installation and wiring
- Requirements governing the installation site
- Minimum clearances
- Installation
- Installation of basic unit
- Installation of casing
- Installing the sheet steel accessories
- Connection to the pipe network
- Sealing the pipework to the valve condensation tray
- Overview of valve kits
- Connection of 2-way valve kit
- Connection of 3-way valve kit
- Connection of differential pressure-dependent valve kit
- Condensation connection
- Electrical wiring
- Electromechanical control, Venkon AC
- Cabling, Venkon AC (*A00M), control by room thermostat type 148916
- Cabling, Venkon AC (*A00M), control by room thermostat type 148916, with condensation monitor
- Cabling, Venkon AC (*A00M), control by room thermostat type 148915/148918/148917
- Cabling, Venkon AC (*A00M), control by room thermostat type 148915/148918/148917, with con
- Electromechanical control, Venkon EC
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30155
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30155, with condensation monitor
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30256
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30256, with condensation monitor
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller Type 148941/148942
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller Type 148941/148942, with condens
- KaControl (*C1)
- Connection (*C1)
- Cabling, Venkon EC, KaControl (*C1*), control by KaController
- Cabling, Venkon EC, KaControl (*C1*), control by in situ 0-10 V DC signal
- Pre-commissioning checks
- Operation
- Operation of the KaController
- Maintenance
- Maintenance work
- Cleaning the main condensation tray
- Cleaning the valve condensation tray
- Clean the inside of the unit
- Faults
- KaControl faults
- List of KaControl parameters
- KaController parameter list
- Certificates
- Table
|
VenkonAssembly, installation and operating instructions102.4 Personnel requirements - QualificationsSpecialist knowledgeThe installation of this product requires specialist knowledge of heating, cooling, ventilation, installation and electrical engin-eering. This knowledge, generally learned in vocational training in one of the fields mentioned above, is not described separ-ately.Damage caused by improper installation is the responsibility of the operator or installer. The installer of these units shouldhave adequate knowledge of the following gained from specialist vocational trainingSafety and accident prevention regulationsGuidelines and recognised technical regulations, i.e. Association of German Electricians (VDE) regulations, DIN and ENstandards.VDI 6022; Maintenance personnel must be trained to Category B (possibly Category C) to comply with hygiene require-ments (if necessary)The installation, operation and maintenance of this unit must comply with the applicable laws, standards, provisions and reg-ulations in the respective country and the current state of the art!2.5 Personal Protective EquipmentPersonal protective equipment is used to protect people from impaired safety and health when working with the unit. The ap-plicable accident prevention regulations at the place of use apply in all cases.Personnel have to wear personal protective equipment during maintenance and troubleshooting on and with the unit.
|
