Contents - Table Of Contents
- Table Of Contents
- Table Of Contents
- General
- Safety
- Limits of operation and use
- Risk from electrocution
- Personnel requirements - Qualifications
- Transport, storage and packaging
- Storage
- Technical data
- Construction and function
- Wear parts list
- Installation and wiring
- Requirements governing the installation site
- Minimum clearances
- Installation
- Installation of basic unit
- Installation of casing
- Installing the sheet steel accessories
- Connection to the pipe network
- Sealing the pipework to the valve condensation tray
- Overview of valve kits
- Connection of 2-way valve kit
- Connection of 3-way valve kit
- Connection of differential pressure-dependent valve kit
- Condensation connection
- Electrical wiring
- Electromechanical control, Venkon AC
- Cabling, Venkon AC (*A00M), control by room thermostat type 148916
- Cabling, Venkon AC (*A00M), control by room thermostat type 148916, with condensation monitor
- Cabling, Venkon AC (*A00M), control by room thermostat type 148915/148918/148917
- Cabling, Venkon AC (*A00M), control by room thermostat type 148915/148918/148917, with con
- Electromechanical control, Venkon EC
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30155
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30155, with condensation monitor
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30256
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller 30256, with condensation monitor
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller Type 148941/148942
- Cabling, Venkon EC (*00M or 01M), control by Climate Controller Type 148941/148942, with condens
- KaControl (*C1)
- Connection (*C1)
- Cabling, Venkon EC, KaControl (*C1*), control by KaController
- Cabling, Venkon EC, KaControl (*C1*), control by in situ 0-10 V DC signal
- Pre-commissioning checks
- Operation
- Operation of the KaController
- Maintenance
- Maintenance work
- Cleaning the main condensation tray
- Cleaning the valve condensation tray
- Clean the inside of the unit
- Faults
- KaControl faults
- List of KaControl parameters
- KaController parameter list
- Certificates
- Table
|
VenkonAssembly, installation and operating instructions61 General1.1 About these instructionsThese instructions ensure the safe and efficient handling of this equipment. These instructions form an integral part of theequipment and have to be kept in the direct vicinity of the equipment and available to personnel at all times.All personnel must have carefully read through these instructions prior to commencing all work on the equipment. A funda-mental prerequisite for safe working is compliance with all the stated safety instructions and other instructions contained inthis manual.In addition all local occupational health and safety at work regulations apply, as do general safety provisions governing theuse of the equipment.Illustrations in this guide are intended to provide a basic understanding and may differ from the actual model.Ongoing tests and further developments may result in small variations between the unit supplied and the instructions.1.2 Explanation of SymbolsDANGER!This combination of symbol and signal word indicates an immediately dangerous situation caused by elec-trical power, which will cause death or serious injury if not avoided.WARNING!This combination of symbol and signal word indicates a possible hazardous situation.IMPORTANT NOTE!It represents a potentially hazardous situation, which could lead to damage to property or for a measure tooptimise workflows.IMPORTANT NOTE!This symbol highlights useful hints, recommendations and information for efficient and trouble-free opera-tion.
|
