— 18 —EnglishRDS features (See page 7)Auto TP Seek FunctionWhen the TI function is on and poor reception conditions areexperienced when listening to a traffic information station,another traffic information station with better reception willbe searched for automatically. This function is on, when unitis first powered on.Turning Auto TP Seek Function On/Off:Hold down the MENU button for one second or more."MENU" is displayed and the menu mode is turned on.Press the ¢ button repeatedly until the Auto TP Seekfunction appears in the display.Press the 4 button to search in the other direction.The function setting is indicated by "ATPS ON" or "ATPS OFF"in the display, indicating that the function is on or off,respectively.Switching settingsPress either the AM button or FM button.The display and setting will change.If the traffic information station you are tuned to experiencespoor reception, this function automatically seeks another TPstation.Press the MENU button to end the menu mode.4321Presetting Volume for Traffic Information/NewsPreset the volume level to be used for traffic information andnews broadcasts.Tune into the station for which you want to set the volume.Adjust the volume to the desired level.Hold down the VOL ADJ button for two seconds or more.The volume level blinks once in the display to indicate that thedata has been stored.Future traffic information/news broadcasts are heard at thepreset level.• The volume cannot be lowered by this function during tunerreception. The volume is only set when it is louder than thelistening volume of the tuner.• You can arrange only to listen to traffic information or newsbulletins with at preset volume with the volume set atminimum.NOTE321