Kenwood KDC-6060R Instruction Manual

Also see for KDC-5060R: Instruction manual

— 33 —Adjusting TimeWith automatic time adjustment, you can set the clock timeautomatically according to time data sent from RDS stations(after receiving RDS signals for several minutes). You can alsoset the time manually if the automatic time adjustmentfunction is turned off. The factory default is automatic timeadjustment.Adjusting Time Automatically:Tune into an RDS station for 3 or 4 minutes.The time adjusts automatically to the correct local time.The time is not adjusted when the RDS station you are tuned tois not transmitting a time signal. Choose another RDS station insuch a case.Turning Automatic Time Adjustment On/Off:Hold down the MENU button for one second or more."MENU" is displayed and the menu mode is turned on.Press the ¢ button repeatedly until the Automatic TimeAdjustment function appears in the display.Press the 4 button to search in the other direction.The function setting is indicated by "SYNC ON" or "SYNC OFF"in the display, indicating that the Automatic Time Adjustmentis on or off, respectively.“SYNC ON” (Automatic time adjustment)“SYNC OFF” (Manual time adjustment)Switching settingsPress either the AM button or FM button.The display and setting will change.Press the MENU button to end the menu mode.Adjusting Time Manually:Turn off the Automatic Time Adjustment as mentioned above.Hold down the MENU button for one second or more."MENU" is displayed and the menu mode is turned on.Press the ¢ button repeatedly until the "CLK ADJ" appears inthe display.Press the 4 button to search in the other direction.3214321NOTEHold down either the AM or FM button for two seconds ormore to enter the Time Adjustment mode.The hour display will blink.• Adjusting the hoursPress the FM button to advance the hours, or press the AMbutton to make the hours go back.• Adjusting the minutesPress the ¢ button to advance the minutes, or press the4 button to make the minutes go back.Press the MENU button to end the menu mode.654DSI (Disabled System Indicator)A red indicator blinks on the unit after the faceplate isremoved, warning potential thieves. The factory default forthis function is "ON".Turning Disabled System Indicator On/Off:Hold down the MENU button for one second or more."MENU" is displayed and the menu mode is turned on.Press the ¢ button repeatedly until the Disabled SystemIndicator function appears in the display.Press the 4 button to search in the other direction.The function setting is indicated by "DSI ON" or "DSI OFF" inthe display, indicating that the disable system indicator is on oroff, respectively.Switching settingsPress either the AM button or FM button.The display and setting will change.Press the MENU button to end the menu mode.4321