— 29 —Disc Name Preset Play (DNPP)Function of remote control with DNPP button (See page 8)If you have preset the name of a disc that you want to listento in the disc changer, you can look for it by name and startplaying it.Press the DNPP button on the remote control."DNP PLAY" will appear in the display, and the disc namepreset play mode is entered.The preset names/disc titles of the disc in the disc changer towhich you are currently listening are successively displayed forfive seconds each.In any of the units that are connected, discs that have not beendisc name preset will display "NO NAME".• This function can only be used in disc changers that weremanufactured or sold as of 1997. Also note that some unitscannot provide a display unless the disc name preset has beenmade by the unit that is playing.NOTE1• Discs in the disc changer that have never been played beforewill appear as "NO ACCES" when the disc names are displayed.When you cannot identify a disc because of the "NO ACCES"display after inserting a disc magazine, try playing it using thedisc scan or a similar function to display the disc name.Also note that "NO DISC" will be displayed when a disc has notbeen loaded.Rapid display (forward / reverse):Press the DISC + or DISC – button.Pressing the DISC + button will rapidly display the presetnames/disc titles in order.Pressing the DISC – button will rapidly display the presetnames/disc titles in reverse order.When the name appears for the disc you want to playPress the OK button.The disc whose name is displayed will be recalled, and the discname preset play (DNPP) mode will end.To cancel DNPP mode:Press the DNPP button.The disc name preset play (DNPP) mode will be cancelled.2• The number of discs whose names can be stored will differdepending on the disc changer that is connected. Please seeyour disc changer manual for details.Up to 10 CDs can be registered with this unit.• Discs are identified by their total length and number of tracks. Ifyou play another CD that happens to have exactly the samespecifications as another CD whose name is stored, the wrongname will be displayed for it.• If you want to change the name of a disc, repeat steps 1 and 2to display the name, and then repeat steps 3 and 4 to enter thechanges.• Pressing the reset button erases the disc nemes stored in thisunit, but does not erase the names stored in a disc changer.NOTE