Kenwood KDC-6060R Instruction Manual

Also see for KDC-5060R: Instruction manual

— 28 —English Presetting Disc NamesStore the names of discs to be displayed when played.Play the disc whose name you want to preset.• This function is not available for disc changers that do not featurethe Disc Name Preset function.• This procedure is not to be used to store the disc and tracktitles for MDs that you record.Hold down the NAME.S button for two seconds or more."NAME SET" is displayed and the disc name preset mode isentered.The cursor blinks in the position where character input can bemade.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.You can also move the cursor left or right by pressing theTRACK + or TRACK – buttons, respectively, on the remotecontrol.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the DISC + or DISC – button to display the desiredcharacter.Characters that can be displayed are as follows.Alphabet (capital letters) : A~ZNumerals/characters : 1~9 0 @ “ ‘ ` % & ∗ + - = , . / \ < > [ ]The operation and characters that can be entered may changeas listed below, depending on the unit that is connected.A press of the 38 button exits the disc name preset mode.Operations can be followed again from Step 2 at a time suchas this, and the characters to be input are selected using theprocedure described below.NOTE432NOTE1Press the DISC + or DISC – button to display the desiredcharacter. Besides the alphabet (capital letters only) andnumbers, you can choose the following characters: /, +, –, *,=, <, >, [ and ].Direct Alphabet InputIf the disc changers that were manufactured and sold after 1997are connected, you can directly input letters using thenumber/letter entry buttons on the remote control.Example: Use the following table to enter the name "DANCE".Continue steps 3 and 4 until all the characters are chosen forthe name.You can enter up to 8 characters for each name.Press either the NAME.S button on the main unit or the OKbutton on the remote control.The disc name is stored and the disc name preset mode iscancelled.If you make no entry in a 10-second period, the name will bestored with the characters entered so far.6NOTE5NOTEButton to press # Times pressedCharacter#3 1“D”1“A” #2#6“N” 2#2 3“C”#3“E” 2Disc control features (See page 7)