Makita EN4951SH Instruction Manual

Also see for EN4950H: Original instruction manual Original instruction manual Instruction manual Instruction manual Original instruction manual

23- Drain fuel from the fuel tank and carburetor according to the following procedure:1) Remove the fuel tank cap, and drain fuel completely.If there is any foreign materials remaining in the fuel tank, remove it completely.2) Pull out the fuel filter from the refill port using a wire.3) Push the primer pump until fuel is drained from there, and drain fuel coming intothe fuel tank.4) Reset the filter to the fuel tank, and securely tighten the fuel tank cap.5) Then, continue to operate the engine until it stops.- Remove the spark plug, and drip several drops of engine oil through the sparkplug hole.- Gently pull the starter handle so that engine oil will spread over the engine, andattach the spark plug.- Attach the cover to the cutting blades.- In general, store the machine in horizontal position. If it is not possible, place themachine as the motor unit comes below the cutting tool. Otherwise engine oilmay leak from inside.- Always pay attention to storing the machine in a safe place to prevent machinedamage and personal injury.- Keep the drained fuel in a special container in a well-ventilated shade.WARNING: When draining the fuel, stop the engine and wait for the engineto cool down.Failure to do so may cause burns or fire.ATTENTION: When you store the machine for a long time, drain all fuel fromthe fuel tank and carburetor, and keep it at a dry and clean place.STORAGEDrain fuel Humidity