4-28 Using the ECU and SCSI Utilities7. Select “Create CFG file.” The “Create a Board CFGFile” screen appears.8. Enter the board description and manufacturer. PressEnter. The “New Board Setup” screen appears.9. Review the manufacturer’s documentation and select theresources used by the board’s current configuration asfollows:n If your board requires interrupts, choose “SelectInterrupts.” Select the interrupts used by the board’scurrent configuration. You must limit your selectionsto seven interrupts.Press F10 when done. The “New Board Setup”screen reappears.NOTE: Press F7 if you need to check the currentallocation of your system’s resources.n If the board requires DMA channels, choose “SelectDMA Channels.” Select the DMA channels used bythe board’s current configuration. You must limityour selections to four DMA channels.Press F10 when done. The “New Board Setup”screen reappears.n If the board requires a port address, choose “SelectPort Addresses.” The “Select Port Addresses” screenappears. Press Insert to enter a port address orDelete to remove a port address. When you pressInsert, the “Add New Port” screen appears.Enter the starting and ending addresses in hexadeci-mal format. Press Enter when you are done. The“New Board Setup” screen appears.
