4-22 Using the ECU and SCSI Utilities5. Select the configuration file you need to copy. You canonly copy one file at a time. Press Enter.You are prompted to remove the configuration diskette.6. Remove the diskette and replace it with the ECUdiskette.After replacing the diskette, the CFG file is copied ontothe ECU diskette.7. Repeat Steps 5 and 6 to copy all the configuration filesyou need onto the ECU diskette.ExitSelect this option to exit the ECU utility.If you are setting up the system for the first time andyou have a SCSI device (such as a SCSI hard disk andCD-ROM reader), see “SCSI Select Utility” later in thischapter.PCI Devices and Plug and Play ISA BoardsWhenever you install a PCI device or Plug and Play ISAboard in the system, run the ECU and select “ConfigureComputer or Peripheral Devices.”This configuration procedure automatically loads configu-ration information and adds the PCI device or Plug and Playboard to the configuration. Select “Step 3: View or EditDetails” to check system parameters and “Step 4: ExamineRequired Switches” to print out system configurationinformation.Be sure to select Step 5 in the Configure Computer orPeripheral Devices menu and save your configuration.
