NEC Image P100E Series Manual

Also see for IMAGE P100E - SERVICE: Service manual

Contents

7-40 Adding Options2. Follow any pre-installation instructions for settingdevice parameters. See Chapter 3, “Setting System Pa-rameters,” and Chapter 4, “Using the ECU and SCSIUtilities.”NOTE: If your 5 1/4-inch device comes with driverails, do not attach them. Remove any rails alreadyattached. See the documentation that comes withthe device.3. Remove the system unit cover (see “Removing and Re-placing the System Unit Cover” earlier in this chapter).WARNING: Be sure that system power isoff andthe system and its peripherals areunplugged beforeyou begin the installation procedure.4. Remove the device bracket from the system as follows:n Remove the four screws (two to a side) holding thefront panel to the system, and remove the panel.