NEC PX1005QL-W User Manual

Also see for PX1005QL-B: User manual

1115. Using On-Screen M enuRESETReset the adjustment value that has been selected in GEOMETRIC CORRECTION (return to the initial value). Itbecomes ineffective when [OFF] is selected for [MODE].• The adjusted value can be reset also by pressing the 3D REFORM button for two seconds or longer on the remotecontrol.[EDGE BLENDING]This adjusts the edges (boundaries) of the projection screen when projecting high resolution videos using a combina-tion of several projectors in the up, down, left and right positions.MODEThis enables or disables the EDGE BLENDING function.When MODE is set to ON, the TOP, BOTTOM, LEFT, RIGHT, BLACK LEVEL, and BLEND CURVE settings can beadjusted.TOP/BOTTOM/LEFT/RIGHTThis selects the EDGE BLENDING locations on the left, right, top and bottom on the screen.The following settings can be adjusted when an item is selected. (→ page 75)CONTROL �� Enable TOP, BOTTOM, LEFT and RIGHT functions�MARKER �� Set whether to display marker or not when adjusting the range and display position� When turned on, amagenta marker for adjusting the range adjustment and a green marker for adjusting the display positionwill be displayed�RANGE �� Adjust the range (width) of the edge blending�POSITION �� Adjust the display position of the edge blending�BLACK LEVELDivide the screen into nine parts and keep the black level uniform for each projector.The nine divisions screens are TOP-LEFT, TOP-CENTER, TOP-RIGHT, CENTER-LEFT, CENTER, CENTER-RIGHT,BOTTOM-LEFT, BOTTOM-CENTER and BOTTOM-RIGHT. (→ page 78)BLEND CURVESet brightness for the EDGE BLENDING section.