NEC PX1005QL-W User Manual
Also see for PX1005QL-B: User manual
                                                                                                                                                                                                           |
1838. Appendix❾ PC Control Codes and Cable ConnectionPC Control CodesFunction Code DataPOWER ON 02H 00H 00H 00H 00H 02HPOWER OFF 02H 01H 00H 00H 00H 03HINPUT SELECT HDMI 02H 03H 00H 00H 02H 01H A1H A9HINPUT SELECT DisplayPort 02H 03H 00H 00H 02H 01H A6H AEHINPUT SELECT BNC 02H 03H 00H 00H 02H 01H 02H 0AHINPUT SELECT BNC(CV) 02H 03H 00H 00H 02H 01H 06H 0EHINPUT SELECT BNC(Y/C) 02H 03H 00H 00H 02H 01H 0BH 13HINPUT SELECT COMPUTER 02H 03H 00H 00H 02H 01H 01H 09HINPUT SELECT HDBaseT 02H 03H 00H 00H 02H 01H 20H 28HINPUT SELECT SLOT 02H 03H 00H 00H 02H 01H ABH B3HPICTURE MUTE ON 02H 10H 00H 00H 00H 12HPICTURE MUTE OFF 02H 11H 00H 00H 00H 13HNOTE: Contact your local dealer for a full list of the PC Control Codes if needed.Cable ConnectionCommunication ProtocolBaud rate �����������������������������������������38400 bpsData length ��������������������������������������8 bitsParity �����������������������������������������������No parityStop bit ��������������������������������������������One bitX on/off ��������������������������������������������NoneCommunications procedure�������������Full duplexNOTE: Depending on the equipment, a lower baud rate may be recommended for long cable runs.PC Control Terminal (D-SUB 9P)NOTE 1: Pins 1, 4, 6 and 9 are no used.NOTE 2: Jumper “Request to Send” and “Clear to Send” together on both ends of the cable to simplify cable connection.NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps.1 52 436 7 98To GND of PCTo RxD of PCTo TxD of PCTo RTS of PCTo CTS of PC |
Related manuals for NEC PX1005QL-B
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine