NEC PX1005QL-W User Manual

Also see for PX1005QL-B: User manual

vImportant InformationPrecautions when installing or replacing the lens unit sold separately (LENSCALIBRATION)After installing or replacing the lens unit, press either the SHUTTER/CALIBRATION button on the main unit or theINFO/L-CALIB. button while pressing the CTL button on the remote control to carry out [LENS CALIBRATION]. (→page 18, 120)By carrying out [LENS CALIBRATION], the adjustment range of the zoom, focus, and shift of the [LENS MEMORY]is calibrated.Contact your dealer to install and replace the lens unit.Remote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it dry immediately.• Avoid excessive heat and humidity.• Do not short, heat, or take apart batteries.• Do not throw batteries into fire.• If you will not be using the remote control for a long time, remove the batteries.• Ensure that you have the batteries’ polarity (+/−) aligned correctly.• Do not use new and old batteries together, or use different types of batteries together.• Dispose of used batteries according to your local regulations.Light Module1. A light module containing multiple laser diodes is equipped in the product as the light source.2. These laser diodes are sealed in the light module. No maintenance or service is required for the performance ofthe light module.3. End user is not allowed to replace the light module.4. Contact qualified distributor for light module replacement and further information.Laser Safety Caution• This product is classified as RG2 of IEC62471-5 Edition 1.0 2015-06.This product is classified as Class 3R of IEC 60825-1 Second edition 2007-03 and Class 1 of IEC60825-1 Thirdedition 2014-05.Also complies with FDA performance standards 21 CFR 1040.10 and 1040.11 for laser products except for devia-tions pursuant to Laser Notice No.50, dated June 24, 2007.Obey the laws and regulations of your country in relation to the installation and management of the device.• Wave length 450–460 nm.• Maximum power: 360 W• The laser module is equipped in this product. Use of controls or adjustments of procedures other than those speci-fied herein may result in hazardous radiation exposure.CAUTION• Use of controls or adjustments or performance of procedures other than those specified herein may result inhazardous radiation exposure.CAUTION – CLASS 3R OF IEC 60825-1 SECOND EDITION LASER PRODUCTLASER LIGHT – AVOID DIRECT EYE EXPOSURE