Engine System, Diesel232Service Manual – CS7000Flash Code Fault Remedy4 Engine shutdown due to engineprotection inputCheck parameter settings.Check what may have triggered the protection input.(Loss of oil pressure, engine overheat)5 Factory settings lost If calibration file is available, download calibration fileand cycle power again.If controller still does not work or if no calibration file isavailable, consult factory.6 APECS unit failed Electrical noise may be entering the controller.Check wiring, shielding and connections to controller.Cycle power to engine.If controller still does not work, consult factory.Glow plug controlThe engine is equipped with glow plugs to assist starting a cold engine. The glow plugs have an internalresistive element that increases in resistance as it heats up. This protects the glow plug from overheating byreducing the current flow as it gets hot.Whenever the key is turned on, the main machine controller tells the control panel to display the “glow plugson” icon and sends out 12 V from connector J3 pin number 32 to the glow plug relay winding. Since the otherside of the winding is connected to ground, this energizes relay which in turn supplies power from circuitbreaker 11 to the glow plugs. After approximately 10 seconds, the main machine controller de-energizesthe glow plug relay by removing the 12 volts from the winding which also removes the power from the glowplugs.
