Dust Control/DustGuard™ Systems91Service Manual – CS7000To Clean the Dust Control FilterCaution: • Wear safety glasses when cleaning the filter.• Clean the filter in a well-ventilated area.• Be careful not to puncture the filter element.1. Check the filter surfaces, and urethane gasket on the bottom of the filter for signs damage. If the filtersurfaces or gasket are damaged, replace the filter.2. Clean the dust control filter using either of the two methods below:Method 1:a. Vacuum any loose dust from the filter.b. Gently tap the filter against a flat surface (with the dirty side down) to remove loose dust and dirt.Method 2:a. Vacuum any loose dust from the filter.b. Blow compressed air (maximum pressure 100 psi) into the clean side of the filter (in the oppositedirection of the airflow).To Reinstall the Dust Control Filter1. Install the Dust Control Filter into therecess in the upper hopper.Note: Make sure the arrow on the“Air Flow” Indicator Decalon the side of the filter ispointing upward.2. Install the Filter Shaker Assembly onto theDust Control Filter. Make sure the shakermotor electrical connector is positionedtoward the rear of the machine.3. Slide the Filter Shaker Assembly towardthe right so the Filter Clamps engage theThumb Nut studs on the upper hopper.4. Tighten the two Thumb Nuts.5. Reconnect the Shaker Motor ElectricalConnector.6. Close the hopper cover.“Air Flow”IndicatorDecalDustControlFilterFilterShakerAssemblyFilterClamp (2)ThumbNut (2)
