Feature implementation 557LD 56 - Configure Conference Warning TonePrompt Response DescriptionREQ CHG Modify existing data.TYPE FTC Flexible Tones and Cadences data block.TABL 0 FTC table number 0. Only table number 0 can be used tomake changes to the Conference Warning Tone....RING NO Modify the ringing feature definitions.HCCT YES Modification of the hardware controlled cadence tonedefinitions allowed....- EEST NO End-to-end Signaling type.- CFWT Conference Warning Tone.- - XTON 0-(3)-255 The Conference Warning Tone number. A tone numberprovided by the tone circuit.- - XCAD 0-(19)-255 The Conference Warning Tone cadence number. Cadencenumber must have been previously set up within LD 56 byresponding to the TYPE prompt with FCAD.LD 97 - Enable Conference Warning TonePrompt Response DescriptionREQ CHG Modify existing data.TYPE XCTP Conference/TDS/MF Sender card parameters.CPAD(0)1Conference pad values.Use software pad values.Use pad values defined by switch settings.DTMF 0-(14)-255 Tone table of the first Dual-tone Multifrequency digit to beused.CFWT (NO) YES (Disable) enable Conference Warning Tone.Note: For CS 1000E Release 5.0 and later, LD 34 must beused to Enable/Disable Conference Warning Tone.LD 34 - Enable Conference Warning ToneCommand DescriptionENLX l Enable Conf/TDS/MFS card on loop l and l + 1.DISX l Disable Conf/TDS/MFS card on loop l and l + 1.Nortel Communication Server 1000Features and Services Fundamentals — Book 2 of 6 (C)NN43001-106 02.04 StandardRelease 5.5 9 May 2008Copyright © 1994–2008, Nortel Networks.
