148 Configuring and managing IP interfaces and servicesNN47250-500 (320657-F Version 02.01)IP interfaces and services configuration scenarioThis scenario configures IP interfaces, assigns one of the interfaces to be the system IP address, and configuresa default route, DNS parameters, and time and date parameters.1 Configure IP interfaces on the wss_mgmt and roaming VLANs, and verify the configurationchanges. Type the following commands:WSS# set interface wss_mgmt ip 10.10.10.10/24success: change accepted.WSS# set interface roaming ip 10.20.10.10/24success: change accepted.WSS# show interface* = From DHCPVLAN Name Address Mask Enabled State RIB---- --------------- --------------- --------------- ------- ----- --------1 default 10.10.10.10 255.255.255.0 YES Up ipv42 roaming 10.20.10.10 255.255.255.0 YES Up ipv42 Configure the IP interface on the roaming VLAN to be the system IP address and verify theconfiguration change. Type the following commands:WSS# set system ip-address 10.20.10.10success: change accepted.WSS# show system===============================================================================Product Name: WSSSystem Name: WSSSystem Countrycode: USSystem Location:System Contact:System IP: 10.02.10.10System idle timeout:3600System MAC: 00:0B:0E:00:04:0C===============================================================================Boot Time: 2000-03-18 22:59:19Uptime: 0 days 01:12:02===============================================================================Fan status: fan1 OK fan2 OK fan3 OKTemperature: temp1 ok temp2 ok temp3 okPSU Status: Lower Power Supply DC ok AC ok Upper Power Supply missingMemory: 156.08/496.04 (31%)Total Power Over Ethernet : 105.6===============================================================================3 Configure a default route through a defaultgateway router attached to the WSS and verify theconfiguration change. Type the following commands: