90 Configuring and managing ports and VLANsNN47250-500 (320657-F Version 02.01)applies default settings appropriate for the port type. Table 1 lists the default settings applied for each port type. Forexample, the AP column lists default settings that WSS Software applies when you change a port type to ap (accesspoint).Table 2 lists how many APs you can configure on a WSS, and how many APs a switch can boot. The numbers are fordirectly connected and Distributed APs combined.Table 1: Port Defaults set by port type changeParameterPort typeAP Access Wired Authentication NetworkVLANmembership Removed from allVLANs. You cannotassign an AP accessport to a VLAN. WSSSoftware automaticallyassigns AP access portsto VLANs based onuser traffic.Removed from all VLANs. Youcannot assign a wiredauthentication port to a VLAN.WSS Software automaticallyassigns wired authenticationports to VLANs based on usertraffic.NoneNote: If you clear a port,WSS Software resets the portas a network port but doesnot add the port back to anyVLANs. You must explicitlyadd the port to the desiredVLAN(s).Spanning TreeProtocol (STP)Not applicable Not applicable Based on the STP states ofthe VLANs the port is in.802.1X Uses authenticationparameters configuredfor users.Uses authentication parametersconfigured for users.No authentication.Port groups Not applicable Not applicable NoneIGMP snooping Enabled as users areauthenticated and joinVLANs.Enabled as users areauthenticated and join VLANs. Enabled as the port is addedto VLANs.Maximum usersessionsNot applicable 1 (one) Not applicableTable 2: Maximum APs supported per switchWSS Model Maximum That Can BeConfiguredMaximum That Can BeBooted2382 320 32, 64, 96 or 128,depending on the licenselevel2380 300 40, 80, or 120, dependingon the license level2360/2361 30 122350 8 3
