Configuring RF load balancing for APs 197Nortel WLAN—Security Switch 2300 Series Configuration GuideSetting strictness for RF load balancingTo perform RF load balancing, AP radios with heavy client loads are less visible to new clients, and causes the newclient to associate with AP radios with a lighter load.You can specify how strictly WSS attempts to load balanced across the AP radios in the load-balancing group. Whenlow strictness is specified (the default), heavily loaded AP radios are less visible and steer clients to less-busy AP radios,while ensuring that clients are not denied service even if all the AP radios in the group are heavily loaded.When maximum strictness is specified and if an AP radio has reached the maximum client load, the AP radio is invisibleto new clients and clients attempt to connect to other AP radios. In the event that all the AP radios in the group reachmaximum client load, then no new clients can connect to the network.To specify load balancing strictness across the AP radios in a load-balancing group, use the following command:set load-balancing strictness {low | med | high | max}• When the low option is set, no clients are denied service. New clients can be steered to other APs, but only tothe extent that service can be provided to all clients. This is the default.• When the med option is set, overloaded radios steer new clients to other APs and clients attempting to connectto overloaded radios may be delayed several seconds.• When the high option is set, overloaded radios steer new clients to other APs and clients attempting to connectto overloaded radios may be delayed up to a minute.• When the max option is set, RF load balancing is strictly enforced. Overloaded radios do not respond to newclients at all, and a client cannot connect during times that all of the detectable AP radios are overloaded.Exempting an SSID from RF load balancingBy default, RF load balancing is applied to client sessions for all SSIDs. To specifically exempt an SSID from loadbalancing, use the following command:set service-profile service-profile-name load-balancing-exempt {enable | disable}When you exempt a service profile from RF load balancing, an AP radio attempting to steer clients a way does notreduce or conceal the availability of the SSID in the profile. If a radio withholds probe responses to manage the clientload, the radio does respond to probes for an exempt SSID. Also, if an AP radio is withholding probe responses, and aclient probes for any SSID, and the radio has at least one exempt SSID, the radio responds to the probe, but the responsereveals only the exempt SSID(s).Displaying RF load balancing informationThe show load-balancing group command displays a load balancing group member radios and current load for eachradio. For example:WSS# show load-balancing group ap 2 radio 1Radios in the same load-balancing group as: ap2/radio1--------------------------------------------------